KQ MiniSynth Clock modules
KQ MiniSynth – All modules
Loop Gate (Tempo Sync)
 |
This outputs -1 or 1 with syncronizing the Tempo.
You can turn on/off gate at fixed timing.
The sequence is Before → Active → After → Before.
The output is 1 when the state is “Active”, -1 when the others.
Connectors / Parameters
|
KQ MiniSynth – All modules
8 Step Sequencer (Version 3.0)
 |
Outputs the specified CV value and the Gate signal of the specified length in order from 1~8 in sync with the tempo.
Output value can be specified for each step from 1~8.
Sends a pulse at Start/Stop to Trigger Out.
Connectors / Parameters
-
1~8
Set the CV output value and Gate signal length for each step.
-
1 Step Duration
The duration per 1 step.
-
Transition Time
Changes the output smoothly during this duration when stepping forward.
The output changes immediately when this value is 0.
-
Sequence Length
The loop does the appointed step.
-
Trigger In Start/Stop
Input a pulse to this to Start/Stop.
-
Trigger Out Start/Stop
Send a signal when this module starts/stops.
-
CV
Output CV value.
-
Gate
Output Gate signal.
|
KQ MiniSynth – All modules
8 Step CV Sequencer
 |
Synchronized with tempo, loops 1~8, and outputs the CV value.
You can set the CV value of each step.
The duration per 1 step is constant.
Connectors / Parameters
-
1…8
Set the CV value of each step.
-
1 Step Duration
The duration per 1 step.
-
Transition Time
Changes the output smoothly during this duration when stepping forward.
The output changes immediately when this value is 0.
-
Sequence Length
The loop does the appointed step.
-
Start/Stop
This module runs when this input is on.
-
Pause
This module pauses during this input is on.
-
CV Out
The output.
|
KQ MiniSynth – All modules
8 Step Gate Sequencer
 |
Synchronized with tempo, loops 1~8, and outputs -1 (off) or 1 (on).
You can set the duration, during which the output is on, of each steps.
The duration per 1 step is constant.
Connectors / Parameters
-
1…8
Set the duration during which the output is on.
-
1 Step Duration
The duration per 1 step.
-
Sequence Length
The loop does the appointed step.
-
Start/Stop
This module runs when this input is on.
-
Pause
This module pauses during this input is on.
-
Gate Out
The output.
|
KQ MiniSynth – All modules
LFO Type B (Tempo Sync)
 |
This is an Low Frequency Oscillator which is synchronized with tempo.
Connectors / Parameters
-
Waveform buttons
Select a waveform among SineWave, TriangleWave, SquareWave, and SawtoothWave.
-
Period
The duration of 1 waveform.
-
Gain
A value for changing the output volume.
-
Sync
Reset the waveform when this input turns on.
-
Wave Out
This outputs a wave.
|
KQ MiniSynth – All modules
Recent Comments